Harbor Freight Tools 62553 - 8 HP OHV Horizontal Shaft Gas Engine EPA/CARB Support and Manuals
Get Help and Manuals for this Harbor Freight Tools item
View All Support Options Below
Free Harbor Freight Tools 62553 manuals!
Problems with Harbor Freight Tools 62553?
Ask a Question
Free Harbor Freight Tools 62553 manuals!
Problems with Harbor Freight Tools 62553?
Ask a Question
Popular Harbor Freight Tools 62553 Manual Pages
User Manual - Page 1
...can result in any parts are open.
Only use...manual or any artwork contained herein may not be reproduced in serious injury. Engine exhaust contains carbon monoxide. Visit our website at: http://www.harborfreight.com Email our technical support at: [email protected] Email our engine support... Manual & Safety Instructions
Save This Manual Keep this manual for assembly and service ...
User Manual - Page 2
...set by the California Air Resources Board (also known as CARB).
For warranty information, refer to the last pages of Contents
Specifications 2 Safety 3 Setup 6 Operationr 8
Maintenances 12 Troubleshooting 16 Warranties 18 Parts Lists and Diagrams 20
Specifications... 20 UNF
The emissions control system for this manual. ITEM 62553 Environmental Protection Agency and by the U.S.
User Manual - Page 3
... to potential personal injury hazards. Read the manual before set-up and/or use. WARNING marking concerning Risk of Fire. Wear hearing protection. Do not smoke while handling fuel. WARNING marking concerning Risk of Hearing Loss. IMPORTANT SAFETY INSTRUCTIONS
WARNING!
Obey all safety messages that follow all instructions listed below may occur.
WARNING marking...
User Manual - Page 4
... Keep hair, clothing and gloves away from moving parts.
18. Use proper fuel storage and handling procedures. Operation of this manual. This is operating.
12. Clean spilled gasoline ...model. Parts, especially exhaust system components, get very hot during set up Precautions
1. Stay clear of this equipment may create sparks that may be caught in the Specifications chart of hot parts...
User Manual - Page 5
... place and in this manual or any service or maintenance procedures not explained in proper working conditions and the work gloves, and dust mask/respirator during service.
5. Maintain labels and nameplates on the equipment.
Refuel in the air.
Page 5 Only a qualified service technician may adjust parts that you are caused by a qualified repair person using . Do...
User Manual - Page 6
...only with proper spark arrestor installed.
Operation of this equipment may be required. WARNING! WARNING! INSTALL THIS ENGINE ACCORDING TO EQUIPMENT INSTRUCTIONS BEFORE USE. ITEM 62553
...INSTALL THIS ENGINE ON A VEHICLE. Safety
Set Up
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this manual including all text under subheadings therein before set ...
User Manual - Page 8
...problems...is recommended for damaged, loose, and missing parts before set up and starting. Close the Fuel Valve....
3. Engine will not start with too little oil.
Clean the top of oil until fixed properly.
Full level
Full level
2.
Setup...each use of this manual including all text under subheadings therein before set up to the ...
User Manual - Page 9
... gasoline containing more than 10% ethanol (E10). Note: Do not use . Then replace the Fuel Cap.
5. To prevent FIRE, do not start the engine while the smell of both unleaded gasoline and oil. Follow the Set Up Instructions in the equipment manual. Inspect the equipment and engine. c. Fill the engine with a fuel stabilizer additive...
User Manual - Page 10
...pull
it as the Throttle. Use the Speed Control Lever in the RUN position.
1
STARTRUN
Setup
Operation
2. Repeat until resistance is so equipped.
2
OFF ON
3
4. Hold it slowly several ... as it recoils so it quickly.
Engine will not start , check engine oil level. Safety
Manual Start
1. Allow Cable to the START position. Note: Some tools have a Speed Control Lever located...
User Manual - Page 12
Follow all service instructions in addition to the regular checks and maintenance explained as a general guide.
Cleaning, Maintenance, and Lubrication Schedule
Note: This maintenance schedule is intended solely as part of the regular operation of use
Yearly or every 300 hr. Note: The following procedures are in this manual, will differ depending on factors such as...
User Manual - Page 16
...qualified technician diagnose/ repair ignition system. ...precautions whenever diagnosing or servicing the equipment or engine...problem, see #3.
3. Clogged Fuel Filter.
8. Reinstall spark plug and set Choke to START position.
3. Connect spark plug cap properly.
2. Correct spark plug gap. 4. Replace...mounted on level surface. Troubleshooting
Problem
Possible Causes
Probable Solutions
...
User Manual - Page 17
...problems.
1. Old or low quality gasoline.
5.
Faulty magneto. 5. Engine too cold.
3. After sudden impact, engine will run, but equipment will not start: COMPRESSION RELATED section.)
1. Probable Solutions
1. Replace spark plug cap. 4. Have qualified technician service...ethanol (E15, E20, E85, etc.).
2. Diagnose and repair compression. (Use Engine will not operate
4. Allow engine ...
User Manual - Page 18
... explanation of the required maintenance listed in your engine will either of this warranty, the product or part must warrant that this manual), neglect, improper maintenance, or unapproved modifications. Where a warrantable condition exists, HFT will repair or replace, at our expense, but if we cannot readily and quickly provide you must accompany the merchandise...
User Manual - Page 19
...3. Any such part repaired or replaced under the warranty will be repaired or replaced HFT. Notwithstanding the provisions herein, warranty services or repairs will be used to the determination that a warranted part is in the written instructions will be warranted for the period of time prior to conform with all retail stores or by contacting HFT product support at all...
User Manual - Page 21
...BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO. Assembly Diagram
66
90 89
82 82
82 82
81
... THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LISTS AND ASSEMBLY DIAGRAMS IN THIS MANUAL AS A REFERENCE TOOL ONLY.
Harbor Freight Tools 62553 Reviews
We have not received any reviews for Harbor Freight Tools yet.